Konica Minolta Bizhub 162 Service Manual page 436

Field Service Ver. 1.0 Apr. 2005
Prohibited original: Original that has a high possibility of causing problems if used.
Type of Document
Original that is stapled or clipped.
Glued original
Book original
Original weighing less than 35g/m
or more
Original with many dog-ears, tears, or wrinkles. Paper take-up failure or damage to the original
Highly curled original (15 mm or more)
OHP film
Label Sheet
Offset master
Original with cutouts
Cut-and-pasted original
Originals not guaranteed for reliable feeding: Original that can be fed to some extent but is
highly prone to cause problems if used.
Type of Document
Original with small curls (amount of curl 10 or
15 mm)
Thermosensitive paper
Inkjet paper
Paper with smooth surface (coated paper)
Translucent original
Paper immediately after it is output from the
copier
Paper with many holes (restricted to vertical
feeding of loose leaf, etc.)
Original with 2 to 4 holes
Folded or Z-fold Original (amount of float 15
mm or less)
Original with bumpy surface (letterhead, etc.)
Original written in pencil
Folded original
Paper take-up failure, damage to the original, or drive
failure due to clip clogging
Paper take-up failure or damage to the original
Paper take-up failure, damage to the original, or drive
failure
2 2
or 129g/m
Paper take-up failure
Original misfeed due to dog-ear or skew
Paper take-up failure
Paper take-up failure
Paper take-up failure
Damage to the original
Dog-ear or tear at the cut-and-paste section
Dog-ear or output failure
Leading edge crease, output failure, or paper trans-
port failure
Paper take-up failure or paper transport failure
Paper take-up failure or paper transport failure
Paper take-up failure or paper transport failure
Paper take-up failure or paper transport failure
Multi-page feed due to flashes from holes
Paper Transport Failure
Paper take-up failure, paper transport failure, or dis-
torted image
Paper take-up failure
Smudged original
Distorted image, multi-page feeding, or paper take-up
failure
1. Product specification
Expected Problem
Expected Problem
3