10. Tech. Rep. Mode; 10.1 Tech. Rep. Mode Function Setting Procedure - Konica Minolta bizhub 200 Service Manual

Hide thumbs Also See for bizhub 200:

Table of Contents

10. Tech. Rep. Mode

• Ensure appropriate security for Service mode function setting procedures. They

should NEVER be shown to any unauthorized person not involved with service

A. Procedure

1. Press the Utility/Counter key.

2. Touch [Check Detail].

3. Press the following keys in this order.

Stop → 0 → 0 → Stop → 0 → 1

4. Enter the 8-digit service code and touch [END]. (Default value: 00000000)

• When [END] is touched after a wrong service code has been entered, the Basic

screen reappears.

• At the fourth access after entries of three wrong access codes, [END] is not avail-

able on the screen. It is therefore necessary to turn OFF and ON the Main Power

• If you forget the service code, it becomes necessary to replace the RAMS Board

with a new one. Take necessary steps not to forget the service code.

• The RAMS Board is not available as a replacement part. If it requires replacement,

contact Office Printing Support Division by way of CSES.

5. The Tech. Rep. Mode menu will appear.

• To change the service code, see "Service Security Mode."

• Touch the [Exit] key.

C. Changing the Setting Value in Service Mode Functions

• Use the +/- key to enter or change the setting value.

• Use the 10-Key Pad to enter the setting value. (To change the setting value, first press

the Clear key before making an entry.)

Confidential – for internal use only, do not distribute

Field Service Ver. 2.5 Jul. 2006

4040F3E543DA

Show Quick Links

Table of Contents

Bizhub 250 Bizhub 350