Toshiba e-STUDIO350 Service Handbook page 637

<Updating Finisher ROM (MJ-1101)>
(1) Attach the ROM to the download jig
Make sure that the ROM and its direction are correct. (P. 6-35 "Fig. 6-29")
(2) Turn OFF the power of the equipment.
(3) Remove 1 screw and take off the board access cover.
(4) Connect the download jig with the jig connector (CN9) on the Finisher control board.
(5) Turn ON the power while pressing [0] and [8] simultaneously.
Updating starts and the LED on the download jig lights
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Board access cover
Fig. 6-59
Download jig
Fig. 6-60
6 - 61
06/01
e-STUDIO350/352/353/450/452/453
FIRMWARE UPDATING
6