Toshiba e-STUDIO350 Service Handbook page 467

[E870] RADF open jam
Is the RADF opened?
YES Remove the original, if any, and close the RADF.
NO
Is the RADF opening/closing sensor adjusted within the specified range?
NO Adjust the RADF opening/closing sensor.
YES
Is the RADF opening/closing sensor working? (Perform the input check: 03-[FAX]ON/[7]/[D])
| NO 1) Check if the connector of the RADF opening/closing sensor is discon-
|
|
2) Check if the connector CN6 on the RADF board is disconnected.
|
3) Check if the connector pins are disconnected or the harnesses are open
|
|
4) Check if the conductor pattern on the RADF board is short circuited or open
|
|
5) Replace the RADF opening/closing sensor.
|
6) Replace the RADF board.
|
YES
Replace the RADF board.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
nected.
circuited.
circuited.
5 - 31
e-STUDIO350/352/353/450/452/453
TROUBLESHOOTING
5