Toshiba e-STUDIO350 Service Handbook page 521

[CC80] Front jogging motor abnormality/Front aligning plate motor abnormality
MJ-1022 (Front jogging motor abnormality)
Is the front jogging plate home position sensor (S6) working properly?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and front jogging motor (M3) correct?
NO Correct the wiring.
YES
Has the rack run over the stopper of the roll?
YES Fix it.
NO
1) Replace the front jogging motor.
2) Replace the finisher controller PC board.
MJ-1023/1024 (Front aligning plate motor abnormality)
Is the front aligning plate home position sensor (PI36) normal?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the front aligning plate motor (M33)
correct?
NO Correct the wiring.
YES
Is there any mechanical problem with the path of aligning plate?
NO Fix the mechanism.
YES
1) Replace the front aligning plate motor.
2) Replace the finisher controller PC board.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
5 - 85
06/01
e-STUDIO350/352/353/450/452/453
TROUBLESHOOTING
5