Toshiba e-STUDIO350 Service Handbook page 485

[EAC0] Transport delay jam
MJ-1024
Is there any paper remaining on the transport path in the finisher, saddle stitcher section or
equipment?
YES Remove the paper.
NO
Is the connector J708 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and inlet sensor (PI33) open cir-
cuited?
YES Connect the connector securely. Replace the harness.
NO
Is the inlet sensor working properly? (Check the movement of the actuator.)
| NO 1) Connect the connector of the sensor securely.
|
2) Attach the actuator securely if its shaft is out of place.
|
3) Replace the sensor.
YES
Replace the finisher controller PC board.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
5 - 49
e-STUDIO350/352/353/450/452/453
TROUBLESHOOTING
5