Toshiba e-STUDIO350 Service Handbook page 394

(5) Press [Button1] and [Button2] as described in the following table to set the B4-size recycled
paper mode. Press [Button1] and [Button2] on the control panel as below to set the B4-size recy-
cled paper mode.
Note: Note:
Be sure to press [Button1] and [Button2] the correct number of times.
Press [Button1] and [Button2] simultaneously to cancel the operation.
B4-size recycled paper mode
Step Buttons
1 Button1
2 Button2
3 Button1
4 Button2
Note: Note:
To change settings from the B4-size recycled paper mode to the normal mode, perform steps (1)
through (4), and then press [Button1] and [Button2] on the control panel as shown below to set
the normal mode.
Normal mode
Step Buttons
1 Button1
2 Button2
3 Button1
4 Button2
(6) When the settings are stored normally, [LED1] on the control panel is lit. [LED1] blinks, if an error
occurs. In this case, turn the power OFF and make the settings again from step (4).
(7) Turn OFF the power of the equipment.
(8) Turn OFF all bits of the SW1 on the Finisher control board.
(9) Install the board access cover.
e-STUDIO350/352/353/450/452/453
ADJUSTMENT
LED3 LED2
Button1
Fig. 3-146
Number of pressing
1
1
8
1
Number of pressing
1
1
6
1
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
3 - 106
06/09
LED1
Button2
Remarks
Confirms the input value
Confirms the input value
Remarks
Confirms the input value
Confirms the input value