Toshiba e-STUDIO350 Service Handbook page 24

Error code Classification
E724 RADF jam
E725
E726
E731
E741
E742
E743
E860
E870
E910 Finisher jam (Bridge
unit)
E920
E930
E940
E950 Job separator jam
E951
E960 Offset tray jam
E961
e-STUDIO350/352/353/450/452/453
ERROR CODE AND SELF-DIAGNOSTIC MODE
Contents
Stop jam at the registration sensor: The trailing
edge of the original does not pass the registration
sensor after its leading edge has reached this sen-
sor.
Stop jam at the read sensor: The trailing edge of the
original does not pass the read sensor after its lead-
ing edge has reached this sensor.
Transport/exit signal reception jam: RADF receives
the transport/exit reception signal from the equip-
ment when no original is at the exposure waiting
position.
Stop jam at the exit sensor: The trailing edge of the
original does not pass the exit sensor after its lead-
ing edge has reached this sensor.
Stop jam at the reverse sensor: The trailing edge of
the original does not pass the reversal sensor after
its leading edge has reached this sensor.
Jam not reaching the reverse sensor (during
reverse feeding): The leading edge of the original
does not reach the reverse sensor when original is
fed from the reverse section.
Jam not reaching the exit sensor (during reverse
feeding): The original does not reach the exit sen-
sor after it has passed the reverse sensor when the
original is exited from the reverse section.
Jam access cover open: The jam access cover has
opened during RADF operation.
RADF open jam: RADF has opened during RADF
operation.
Jam at the bridge unit transport sensor-1: The
paper does not reach the bridge unit transport sen-
sor-1 after it has passed the exit sensor.
Stop jam at the bridge unit transport sensor-1: The
trailing edge of the paper does not pass the bridge
unit transport sensor-1 after its leading edge has
reached the sensor.
Jam at the bridge unit transport sensor-2: The trail-
ing edge of the paper does not reach the bridge unit
transport sensor-2 after its leading edge has
reached the bridge unit transport sensor-1.
Stop jam at the bridge unit transport sensor-2: The
trailing edge of the paper does not reach the bridge
unit transport sensor-2 after its leading edge has
reached the bridge unit transport sensor-2.
Jam not reaching the job separator transport
switch: The paper has passed through the exit sen-
sor does not reach the job separator transport
switch.
Stop jam at the job separator transport switch: The
trailing edge of the paper does not pass the job sep-
arator transport switch.
Jam not reaching the offset tray transport switch:
The paper has passed through the exit sensor does
not reach the offset tray transport switch.
Stop jam at the offset tray transport switch: The
trailing edge of the paper does not pass the offset
tray transport switch.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
2 - 4
06/01
Troubleshooting
P. 5-28
P. 5-28
P. 5-28
P. 5-29
P. 5-29
P. 5-30
P. 5-30
P. 5-30
P. 5-31
P. 5-32
P. 5-32
P. 5-32
P. 5-32
P. 5-10
P. 5-10
P. 5-10
P. 5-10