Toshiba e-STUDIO350 Service Handbook page 611

PWA-DWNLD-350-JIG2 (48MB)
Important:
The download jig (PWA-DWNLD-350-JIG) is the jig in which the Flash ROM is mounted on the
board directly. Therefore, ROM writer adapter (PWA-DL-ADP-350) is required to write the data to
these Flash ROMs. Refer to the following to write the data.
P. 6-50 "6.2.2 Writing the data to the download jig (PWA-DWNLD-350-JIG)"
K-PWA-DLM-320
Important:
Pay attention to the direction of the ROM.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Connector
( for SYS board
connection )
ROM4
ROM5
ROM6
Fig. 6-28 Jig board: PWA-DWNLD-350-JIG2 (48 MB)
Connector Mark for ROM
installation direction
Fig. 6-29 Jig board: K-PWA-DLM-320
6 - 35
05/11
Connector
( for ROM writer
adapter connection )
ROM1
ROM2
ROM3
LED
ROM
e-STUDIO350/352/353/450/452/453
FIRMWARE UPDATING
6