Toshiba e-STUDIO350 Service Handbook page 425

* k2. Thermistor
Clean the thermistor with alcohol if the toner or dirt is sticking to it when the fuser roller is
replaced.
Do not deform or damage the thermistor during the cleaning. Replace the thermistor with a
new one if it is damaged or deformed regardless of degree.
* o1. Idling roller
Apply one-rice-grain-amount of white grease (Molykote X5-6020) to each part A in the fig-
ure below.
* p1. OCT separator roller
Apply one-rice-grain-amount of FLOIL (GE-334C) to the part A in the figure below. Also
apply three-rice-grain-amount of white grease (Molykote X5-6020) to each part B.
B
A
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-22
Fig. 4-23
4 - 25
04/05
A
B
e-STUDIO350/352/353/450/452/453
PREVENTIVE MAINTENANCE (PM)
4