Toshiba e-STUDIO350 Service Handbook page 331

[A] Assembling carriage wires
Winding the wire around the wire pulley:
(1) Pull the Ø3 ball terminal located at the center of the wire into a hole on the wire pulley. One end
of the wire with a hook attached comes to the outside.
(2) Wind the wires around the wire pulleys of the front and rear sides. The number of turns to be
wound are as follows:
• 2 turns toward the opposite side of the boss
• 4 turns toward the boss side
Note: Note:
Pay attention to the following when the wires are wound around the pulleys:
- Do not twist the wire.
- Wind the wires tightly so that they are in complete contact with the surface of the pulleys.
- Each turn should be pushed against the previously wound turn so that there is no space
between them.
2 turns
Ball terminal
Hook
[Rear]
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
4 turns
No space between turns
Color: Silver
Color: Black
Fig. 3-36
3 - 43
4 turns
2 turns
Ball terminal
Hook
[Front]
e-STUDIO350/352/353/450/452/453
3
ADJUSTMENT