Toshiba e-STUDIO350 Service Handbook page 520

[CC61] Punch motor (M3) home position detection error
* The [CC61] error will be displays when the [E9F0] error occurs three times in succession or
during the initial operation.
MJ-1101 (When MJ-6101 is installed)
Is there any paper remaining on the transport path?
YES Remove the paper.
NO
Rotate the punch motor (M3). Does it rotate smoothly?
NO Fix the mechanism.
YES
Are the punch home position sensor (S4) and its wiring correct?
NO Replace the sensor. Correct the wiring.
YES
Is the wiring between the hole punch control PC board (HP) and punch motor (M3) correct?
NO Correct the wiring.
YES
1) Replace the punch motor (M3).
2) Replace the hole punch control PC board (HP).
[CC71] Punch ROM checksum error
MJ-1101 (When MJ-6101 is installed)
Is the conductor pattern on the hole punch control PC board (HP) open circuited or short cir-
cuited?
YES Replace the hole punch control PC board (HP).
NO
Replace the finisher control PC board.
[CC72] Punch RAM read/write error
MJ-1101 (When MJ-6101 is installed)
Is the conductor pattern on the hole punch control PC board (HP) open circuited or short cir-
cuited?
YES Replace the hole punch control PC board (HP).
NO
Replace the finisher control PC board.
e-STUDIO350/352/353/450/452/453
TROUBLESHOOTING
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
5 - 84
06/01