Toshiba e-STUDIO350 Service Handbook page 294

Note: Note:
When paper thinner than specified is used, paper jams may occur frequently at the registration
section. In this case, it is advisable to change (or reduce) the aligning amount.
However, if the aligning amount is reduced too much, this may cause the shift of leading edge
position. So, when adjusting the aligning amount, try to choose the appropriate amount while
confirming the leading edge position is not shifted.
* As a tentative countermeasure, the service life of the feed roller can be extended by increas-
ing the aligning amount.
e-STUDIO350/352/353/450/452/453
ADJUSTMENT
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
3 - 6