Toshiba e-STUDIO350 Service Handbook page 25

Error code Classification
E9F0 Finisher jam (Puncher
unit)
EA10 Finisher jam (Finisher
unit)
EA20
EA21
EA30
EA31
EA32
EA40
EA50
EA60
EA70
EA80 Finisher jam (Saddle
stitcher unit)
EA90
EAA0
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Contents
Punching jam: Punching is not performed properly.
[MJ-1023/1024 (when MJ-6004 is installed)]
[MJ-1101 (when MJ-6101 is installed)]
Paper transport delay jam: The paper which has
passed the bridge unit does not reach the inlet sen-
sor. [MJ-1022/1023/1024/1101]
Paper transport stop jam:
(1) The paper does not pass through the inlet sen-
sor. [MJ-1022/1023/1024]
(2) The paper has passed through the inlet sensor
but does not reach or pass the feed path sensor or
processing tray sensor. [MJ-1023/1024]
(3) The paper which has passed through the inlet
sensor does not reach the transport sensor. [MJ-
1101]
Paper size error jam: Paper does not reach the sen-
sor because the paper is shorter than spec. [MJ-
1101]
Power-ON jam:
(1) Paper exists at the inlet sensor when power is
turned ON. [MJ-1022/1023/1024]
(2) Paper exists at the feed path sensor or process-
ing tray sensor when power is turned ON.
[MJ-1023/1024]
Transport path paper remaining jam: The paper
which has passed through the inlet sensor does not
reach the transport sensor. [MJ-1101]
Exit paper remaining jam: The paper is remaining
on the finishing tray when the power is turned ON.
[MJ-1101]
Door open jam:
(1) The finisher has been released from the equip-
ment during printing. [MJ-1022]
(2) The upper/front cover of the finisher unit or the
upper/front door of the puncher unit has opened
during printing. [MJ-1023/1024]
(3) The front cover or stationary tray cover is
opened during paper transport. [MJ-1101]
Stapling jam: Stapling is not performed prop-
erly.[MJ-1022/1023/1024/1101]
Early arrival jam: The inlet sensor detects the paper
earlier than a specified timing. [MJ-1022/1023/
1024/1101]
Stack delivery jam: It cannot deliver the stack of
paper on the intermediary process tray to the stack
tray. [MJ-1022]
Stack exit belt home position error: The stack exit
belt is not at the home position. [MJ-1101]
Stapling jam: Stapling is not performed properly.
[MJ-1024]
Door open jam: The delivery cover or the inlet cover
has opened during printing [MJ-1024].
Power-ON jam: Paper exists at No.1 paper sensor,
No. 2 paper sensor, No.3 paper sensor, vertical
path paper sensor or delivery sensor when power is
turned ON. [MJ-1024]
2 - 5
06/01
Troubleshooting
P. 5-50
P. 5-33
P. 5-35
P. 5-36
P. 5-37
P. 5-38
P. 5-38
P. 5-39
P. 5-42
P. 5-44
P. 5-45
P. 5-47
P. 5-47
P. 5-48
e-STUDIO350/352/353/450/452/453
ERROR CODE AND SELF-DIAGNOSTIC MODE
2