Toshiba e-STUDIO350 Service Handbook page 525

[CDE0] Paddle motor abnormality
* You receive a [CDE0] error when the [ED15] error occurs three times in succession or during
the initial operation.
MJ-1101
Is there any mechanical problem with the paddle is rotated?
YES Fix the mechanism.
NO
Is the harness between the paddle motor (M8) and the finisher control PC board (CN6) discon-
nected or open circuited?
l YES •
•
NO
1) Replace the paddle motor (M8).
2) Replace the finisher control PC board.
[CE00] Communication error between finisher and puncher unit
MJ-1023/1024 (When MJ-6004 is installed)
Is the problem solved by turning OFF and ON the power of the equipment?
YES End.
NO
Is the wiring between the finisher controller PC board and punch controller PC board correct?
NO Correct the wiring.
YES
1) Replace the finisher controller PC board.
2) Replace the punch controller PC board.
[CE00] Punch communication error
MJ-1101 (When MJ-6101 is installed)
Is the harness between the hole punch control PC board (HP) and the finisher control PC
board disconnected or open circuited?
YES Replace the harness. Correct the wiring.
NO
Is the conductor pattern on the hole punch control PC board (HP) open circuited or short cir-
cuited?
YES Replace the hole punch control PC board (HP).
NO
Replace the finisher control PC board.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Reconnect the connector securely.
Replace the harness.
5 - 89
06/01
e-STUDIO350/352/353/450/452/453
TROUBLESHOOTING
5