FS-110/FS-210
[3] Removing and Reinstalling the Paper
Exit Opening Unit
Caution:
Make sure that the power cord of the main
body is unplugged from the power outlet.
a.
Procedure
(1) Remove the following parts:
• Top cover/1 or optional PI (if installed)
• Top cover/2
• Side cover
• Rear cover
• Main tray
• Main paper exit opening cover
(2) Remove a mounting screw on the paper exit
open/close link.
Paper exit opening unit
Paper exit open/close link
Screw
3-8
(3) Remove three screws holding the clamps, one
screw holding the ground. Also remove the con-
nector (CN110) for the paper exit opening SD
(SD704) and the main tray paper exit PS
(PS706).
Screw holding the ground cable
Paper exit opening SD (SD704)
Connector(CN110)
Screw holding the clamp
Main tray paper exit PS
(PS706)
Screw holding the clamp
(4) Remove the two E-rings and the two shaft hold-
ers (at the front and rear side). Remove the paper
exit opening unit.
Bearing
E-ring
Paper exit opening unit
(5) Reinstall the above parts following the removal
steps in reverse.
Connector
E-ring
Bearing