Konica Minolta FS-110 Service Manual page 56

FS-110/FS-210
(3) Second sheets of the second and subsequent
sets
When PS704 (FNS entrance) has detected the
trailing edge of the second sheet of the second
(and subsequent sets), and a predefined time
period has elapsed, M713 (stacker entrance)
rotates as a high speed. This action allows the
first and second sheets to be conveyed to the
stacker section at the same time.
(4) Third and subsequent sheets of the second and
subsequent sets
The third and subsequent sheets of the second
(and subsequent sets) are conveyed to the
stacker in the same manner as the sheets of the
first set.
c. Folding and stitch-and- folding modes
The FNS operation signal from the main body
lets M713 (stacker entrance) start to rotate at a
high-speed.
When PS705 (stacker entrance) has detected
the rear end of the paper, the rotation speed of
M713 changes to low, conveying the paper
slowly to the stacker. Then, after a predefined
time has elapsed, the rotation returns to the high-
speed mode to prepare for the next conveyance
of paper.
When the last sheet of the set has been aligned,
M713 stops.
When PS725 (folding paper exit) has detected
the rear end of the set, M713 (stacker entrance)
returns to its high-speed rotation mode to pre-
pare for the next paper conveyance.
d. Three-folding mode
The FNS operation signal from the main body
lets M713 (stacker entrance) start to rotate at a
high-speed.
When PS705 (stacker entrance) has detected
the trailing edge of the paper, the rotation speed
of M713 changes to low, conveying the paper
slowly to the stacker. Then, after a predefined
time has elapsed, the rotation returns to the high-
speed mode to prepare for the next conveyance
of paper.
When the last sheet of the set has been aligned
and the booklet stopper has moved to the three-
folding position, M713 stops.
When PS729 (folding full) has detected the trail-
ing edge of the set, M713 (stacker entrance)
returns to its high-speed rotation mode to pre-
pare for the next paper conveyance.
2. Signals
a. FNS CB output signals
(1) M713 CLK (FNS CB to RB)
Signal relating to the clock for controlling the
rotation speed of M713
(2) M713 RESET (FNS CB to RB)
Reset signal for M713
(3) M713 CONT (FNS CB to RB)
Signal to activate or deactivate M713
[L]: M713 ON
[H]: M713 OFF
b. RB output signals
(1) M713 DRV A, A (RB to M713)
Pulse signal to drive/control the Phase A of M713
(2) M713 DRV B, B (RB to M713)
Pulse signal to drive/control the Phase B of M713
2-26