Table of Contents
Advertisement
FS-110/FS-210
[2] Removing and Reinstalling the
Clincher
Caution:
Make sure that the power cord of the main
body is unplugged from the power outlet.
Caution:
Do not use hands to move stapler units to
horizontal direction.
(Otherwise the belt and the gear teeth skip-
ping may occur.)
Caution:
Be sure to perform the adjustment work
described in the "FNS Stapler Upper/
Lower Positions Adjustment" of the man-
ual, "Adjustment," after you have attached
the clincher.
a.
Procedure
(1) Open the front door.
(2) Pull the stacker unit out and remove the stapler
unit cover.
(3) Remove a mounting screw holding the ground
cable. Remove the ground cable and the clamp.
(4) Remove four screws securing the clincher.
Detach the clincher/F and the connector.
Clamp
MODEL
7155/7165
SERVICE HANDBOOK
Clincher/F
Screw
Connector
Screw
Ground
MANUAL
REVISED EDITION
(5) Remove four mounting screws holding the
clincher/R.
(6) Remove two screws. Detach the ball bearing
bracket, and then remove the clincher/R by rotat-
ing it to the appropriate position. Remove the
connector.
CAUTION: Do not lose the bearing spring and
the ball.
Bearing spring
Ball bearing mounting bracket
(7) Reinstall the above parts following the removal
steps in reverse.
DATE
PAGE
Nov. 2001
3-16
Clincher/R
Screw
Ground
Screw
Clincher/R
Connector
Screw
METHOD
REPLACEMENT
Advertisement
Table of Contents
