Table of Contents
Advertisement
FS-110/FS-210
(11) Loosen the two screws securing the front wire
bracket. Adjust the height of the front wire
bracket to level the up/down stay. Tighten the four
mounting screws on the wire brackets (front and
rear).
CAUTION: Make sure that the up/down stay is
level. If the stay is mounted aslant, an
unnecessary load is put on the tray
up/down motor (M703) or the gear,
which may result in damage to these
components.
Wire bracket
Screws
(12) Reinstall the above parts following the removal
steps in reverse.
b. Procedure (In the case of the new type)
2
(1) Remove the following parts.
• Side cover
• Front door
• Rear cover
• Main tray
MODEL
7155/7165/7255/7272
Mounting
screws
Wire bracket
Up/down stay
MANUAL
REVISED EDITION
SERVICE MANUAL
(2) Remove five screws to detach the reinforcing
bracket and then remove one connector and a
cable assembly from the clamps.
CAUTION: For FS-110 and FS-210 models, the
up/down motor is installed upside
down and therefore the positions of
connector (CN106) and the mount-
ing holes for the reinforcing bracket
are different.
In the case of the FS-110
Clamp
Reinforcing bracket
In the case of the FS-210
Clamp
Reinforcing bracket
DATE
3-12
Dec. 2003
2
Connector (CN106)
Screws
fs2103002
Connector (CN106)
Screws
fs2103003
PAGE
METHOD
3-12
REPLACEMENT
Advertisement
Table of Contents
