Konica Minolta FS-110 Service Manual page 34

FS-110/FS-210
*2 By-pass Gate
The by-pass gate is located on the path to the
stacker. This gate changes the conveyance path
of the next sheet while the stapling is being per-
formed, saving time and improving performance.
This gate is used for small size papers (A4, B5,
and 8.5 x 11). The gate changes the feeding
direction of the second sheet so that it is laid over
the first sheet. The first and second sheets will be
conveyed to the stacker simultaneously.
The by-pass gate SD (SD705) drives the by-
pass gate.
First paper of the second and
subsequent sets
By-pass gate
By-pass gate SD (SD705)
Second paper of
the second and
subsequent sets
By-pass gate SD (SD705)
First paper of the second
and subsequent sets
Second paper of the second
and subsequent sets
First paper of the second
and subsequent sets
By-pass gate
*3 Shift Mechanism of the Shift Unit
The FNS conveyance motor (M701) drives the
shift roller, conveying the paper forward to the
main tray.
While the paper is conveyed to the main tray, the
shift motor (M702) rotates to activate the crank
mechanism. This mechanism moves the shift
moving section (including the shift roller) by
300mm toward the rear, which also moves the
paper and then it is delivered.
The shift HP PS (PS718) detects the shift posi-
tion.
To main tray
Fixed section
Shift HP PS (PS718)
Shift moving section
Shift HP PS (PS718)
Fixed
section
Shift moving section
2-4
Crank arm
Shift motor
(M702)
From FNS conveyance
motor (M701)
Shift roller
Position for straight
Paper exit
Shift motor (M702)
Shift roller
Crank shaft
Position for offset
(shift) paper exit