Konica Minolta FS-110 Service Manual page 72

Note the following points when you detach the finisher from the main
body:
1. Be sure the power cord has been unplugged from the wall outlet.
2. The disassembled parts must be reassembled following the disas-
sembly procedure in reverse unless otherwise specified.
3. Care should be taken not to lose small parts. Care should also be
taken not to install small parts in wrong places.
4. Do not operate the machine before installing all the disassembled
parts completely.
5. Removal of some screws is prohibited in this section. Never loosen
them.
6. For FS-210, the booklet tray must be removed prior to starting the ser-
vice. If the unit is moved with the booklet tray attached, the mounting
section may be damaged.