Konica Minolta FS-110 Service Manual page 83

(7) Secure the end of a new up/down wire to the wire
2
end of the up/down pulley/L. Wind the wire tightly
around the up/down pulley/L five and half turns
(FS-110) / approx. five turns (FS-210) from
inside to outside. Insert the pulley/L into the shaft
with the pin groove faced inward so that the slots
on the pulley/L align with the lock pin on the shaft.
Up/down pulley/L
Inside
(5 turns)
Outside
(8) Hook the up/down wire around the up/down pul-
2
ley/U. Wind the wire tightly around the up/down
pulley/L two and half turns (FS-110) / two turns
(FS-210) from inside to outside. Secure the end
of the wire to another wire end (outside) of the up/
down pulley/L.
Up/down puller/U
Wire end
(2 turns)
Up/down puller/L
MODEL
7155/7165/7255/7272
Lock pin
Wire end
MANUAL REVISED EDITION
SERVICE MANUAL
(9) Insert the pin into the hole in the shaft. Put the
gear into the shaft and fix the gear with the E-
ring.
Pin
Gear
E-ring
(10) Use a tension gauge or a spring balance to pull
the belt tensioner upward at a specified level of
force, A, and tighten the securing screws.
Specified force: A = 2.5±0.25kg
A = 2.5 0.25kg
Belt tensioner
DATE
3-11
Dec. 2003
2
FS-110/FS-210
Screws
PAGE METHOD
3-11 REPLACEMENT