Removal & Installaton Of Front Window Regulator - Chery automobile Service Manual

REMOVAL & INSTALLATON OF FRONT WINDOW REGULATOR
REMOVAL
----Before removal of front window regulator,
the trim panel and waterproof film shall be
removed first following instructions.
----Loosen six screws that secure window
regulator to the inner panel of the door as
shown in the figure.
----Disconnect the motor connector of window
regulator and take out the regulator.
Removal of window regulator is performed
separately from that of glass.
INSTALLATION
Install in the reverse order of removal.
NOTE
----Tightening torque for bolts or nuts of
window regulator is M=9±1N.m.
----Installation size for glass bracket is 105mm
as shown in the figure.
----Tighten the six screws of window regulator
only after the glass is fully raised till the top
and can run up and down smoothly.
----After installation and adjustment, the glass
should run up and down smoothly. Any
shaking, vibration or shock is not allowed.
The up or down movement of glass shall
be finished within 3±1S.
S-38
105