Chery automobile Service Manual page 276

----Install upward the rear shock absorber assy
from the vehicle body bottom and extend
the piston rod into the carriage through the
rear shock absorber holder;
----Inside the carriage, cover bowl washer 17,
rubber bearing block 18 and support disc
19 onto the piston rod in sequence, and
then tighten the hexagon nut 20 with
tightening torque of 20N·m. (shown as
the assy picture above)
----Lift the vehicle, and then put the
connecting sleeve of the rear shock
absorber into
installation position on the rear axle assy
and then tighten the bolt 21 and the nut
22 with the specified torque (70 7N· m)
----Fix the tire, ground the vehicle and
tighten the hexagon thin nut 20 with the
specified torque (25 N·m)
----Fix the belleville washer 3 and tighten the
hexagon thin nut 1 with the specified
torque (15 N·m)
----Fix the rear shock absorber upper cover 2,
in order to keep away from the dust and
dirt which could lead to abnormal wear on
the piston rod. (shown as the picture)
the corresponding
M-27