Assembly - Chery automobile Service Manual

See the picture, fix the special tool on flange
by M8 bolt, rotate the shaft of special tool by
wrench to disassemble the output flange.
Take off spring seat and compression spring.
Fasten the special tool on oil seal, rotate the
special tool threaded shaft by wrench until
screw off the oil seal.

Assembly:

Use the right size oil seal and lubricate its lip.
Put it to its right position by special tool and
rotate the screw of the special tool make oil
seal to its true position.
For the assembly of output flange, you can
use press or special tool press it into its
position, see the picture.
Assemble dish washer and check if it is at its
right position
Assemble snap ring and make sure it is inside
of snap ring groove.
Assemble a new flange cover.
Connect drive shaft and output flange
together, if it is necessary put lubricant to the
stipulated position.
J-43
Special Tool
Special Tool
Special Tool
Special Tool