Operation Method And Function Introduction Of Diagnostic Tester - Chery automobile Service Manual

OPERATION METHOD AND FUNCTION INTRODUCTION OF DIAGNOSTIC
TESTER
* Connect the diagnostic tester with the diagnostic socket (behind the glove box) under
the condition of power off, and then turn on the ignition switch.
* Turn on the power supply of the diagnostic instrument, and select the "A15LHD Series"
* Select the "MK20-I/E Type ABS System"
* Select the appropriate function item/channel number
* CH 01 – Status information display
* CH 02 – Failure inquiry
* CH 03 – Hydraulic Control Unit Diagnostic
* CH 04 – Fluid refilling and air bleeding
* CH 05 – Clear DTC memory
* CH 06 – End and Exit
* CH 07 – Controller coding
* CH 08 – Measured data display, such as wheel speed signal and etc.
* For example, ABS, ECU's versionor part number.
A15LHD-3550010
Coding: 01901
* Read the DTCs
* Click the "MK20-I/E Type ABS System", select the "DTC", and press the "OK" button,
in this case, the DTC will display on the screen if there is a DTC.
* Clear the DTC
1 Press the "Clear" button on the instrument after the TDC readout.
2 In this case, the following will display on the screen
If the failure is removed after pressing the "Yes" button, the DTC can be cleared
completely.
Want to clear the DTC?
[Yes]: Delete it (key ON, and engine OFF)
P-24