Chery automobile Service Manual page 379

----Remove electrical wiring connector, and
pull out the bolts between door and the
hinge on front column, door check, while
another operator
Tightening torque is 56 N·m.
----A layer of protective material shall be
added between the door and the surface on
which the front door is to be placed.
----Perform spray coating as per "Steel plate spray coating process".
----If adjust the door vertically or horizontally, the hinge joint bolts shall be loosened at a
rated pressure with specified adjustment tool for inner hinge, slowly in a paralleled plain
direction, otherwise it would lead to material fatigue. Don't move the tool vertically,
which would result in damage and can only be corrected through re-welding the hinge, to
prevent the already spray coated vehicle paint from generation of cracks. Sealing wax
should be applied to the coat.
----After the door has been adjusted, tighten the bolts at a tightening torque of 56 N.m.
NOTE:
When door is closed, the sealing ability is assured through the seal around the door
opening. If the seal is not perforated for easy entry of air, or the pressure is too large
when door is shut, it would most possibly fail for door shut due to an abnormal pressure.
If any following parts on the door are to be removed, the door trim panel must be
removed first as per the instruction on "Lining & Trim".
----Removal of lock control unit. During the
removal of lock, remove the clip of control
unit and lock. The lock is secured on the
door through two screws for which the
tightening torque is 20 2 N·m as shown
in the right figure.
NOTE
Red thread adhesive shall be applied when
installing the two bolts.
----Remove the bolt between outside handle
and doorframe, and rock the handle
forward, and the handle is to be removed
when 90° is reached. Tightening torque for
the bolt is 7.2±0.2N·m.
----For any model with central locking system,
electrical wires shall be removed too.
remove the door.
S-32