Removal & Installation Of Rear Bumper - Chery automobile Service Manual

REMOVAL & INSTALLATION OF REAR BUMPER
REMOVAL:
----Remove partial lining of rear wheel house.
Loosen the bolts between the lining and
rear bumper.
----Loosen the bolts between trunk support
and trunk floor.
----Loosen the bolt between rear bumper and
trunk.
----Remove the bolt between rear bumper and
floor bottom.
----Slide the bumper backward until it is
disconnected with its bracket.
REMOVAL OF BRACKETS
----Loosen the bolts between bumper and its
brackets to remove the brackets.
----Install the bumper in the reverse order
of removal. Note that tightening torque
for the bolt between the brackets and
floor cross member is 25N·m. Place the
brackets horizontally with ground.
S-10