Disassembly/Assembly And Inspection Of Front Wheel Disc Brake - Chery automobile Service Manual

* Maintenance of Brake Pedal
-- Check the smooth operation of brake pedal, and remove it for inspection if its operation is
abnormal. Check whether the brake pedal is distorted or deformed, and replace it if any.
-- Check whether the brake pedal shaft is worn seriously or deformed, and replace it if any.
All shaft pins shall be lubricated when assembling.

DISASSEMBLY/ASSEMBLY AND INSPECTION OF FRONT WHEEL DISC BRAKE

REMOVAL AND INSTALLATION OF FRONT WHEEL DISC BRAKE
Removal:
-- Lift up the vehicle and remove the front wheel.
-- Loosen and remove the fixing bolt (where the
arrow points).
-- Detach the caliper housing and then remove the
brake lining.
Install it in the reverse order of removal.
Installation:
-- The brake lining with a larger friction surface shall
be installed outside when installing the brake
block.
-- The brake linings on both sides shall be replaced
at the same time with the products provided by the
same one manufacturer when replacing.
-- The tightening torque of securing bolt shall be
25±2Nm (as shown in the figure).
-- The tightening torque of wheel bolt shall be
110±10Nm.
-- The brake disc shall be replaced when the wear
limit of 10 mm reaches. Remove the caliper
housing firstly before replacing the brake disc.
Remove the dirt and anti-rust oil on the friction
surface of new brake disc before it is installed.
P-5