Engine Stall; Control System - Chery A1 2008 Operating Instructions Manual

Clear away snow, fallen
leaves and other foreign materials
blocking at air inlet to ensure
ventilation effect of the vehicle.
SELF-ADAPTING
ABILITY OF THE
ENGINE'S

CONTROL SYSTEM.

If the battery cable has been removed from
the accumulator, the car may present itself
some abnormal phenomena in the initial
stage of running after the cable be
reconnected. This is normal in that the
engine's control system is re-studying to
adapt the engine.
INTRODUCTION OF DRIVING
CONFINING
ENGINE'S RPM
To protect the engine, its RPM is confined
by an electronic unit (ECU).

ENGINE STALL

Release the accelerator pedal. Wait until
the engine's RPM falls to idle speed, and
then turn off the ignition switch.
Do not push down the
accelerator pedal before turning off
the engine.
Do not turn off the engine immediately
THE
when parking after a long time high-speed
running, and leave the engine continue to
run two minutes at a RPM higher than the
idle speed RPM so that the engine's
temperature can fall gradually.
The engine's temperature will
remain high after you turn off the
ignition switch and the engine stalls, so
let the electronic cooling fan of the
radiator continue to run about 10
minutes. Even if the cooling fan stops,
it may run again suddenly because of
high temperature. Therefore, when
working beside the engine, extra care
must be taken.