Chery automobile Service Manual page 500

Connect the airbag and the airbag activation purpose battery with two extra wiring harnesses
of at least 10 meters long each;
Peel off the 13 mm insulated outer layer of the two extra wiring harness ends;
Tie the two ends of the two extra wiring harnesses where its insulated outer layers have been
peeled off;
Place the tied ends beside the airbag activation purpose battery, but remember not to connect
to the battery at this moment;
Connect the other two loose ends separately to join the wiring harnesses connecting the
airbag;
Bind the joint point with insulated tape;
Each end of the two extra wiring harnesses should be connected to the two wiring harnesses
of the airbag separately, and the other end of the extra wiring harnesses should be tied
together and place beside the airbag activation purpose battery. Clear the site.
Loosen the tied end beside the airbag activation purpose battery;
Connect one wire to the negative grid of the battery, connect the other wire to the positive
grid of the battery, and the airbag is immediately activated.
Dispose the activated airbag according to the proper preventive measures. Please refer to the
"Disposal of activated airbag" of this manual.
(11) Activating the airbag before discarding
This specification is applicable for all kinds of vehicles to be discarded and disassembled. If
the vehicle is within the guarantee period, please contact the region maintenance manager for
the approval and other specifications before activating and spreading the airbag. Besides the
extra steps listed below, the activated and spread airbag should be treated with the same
measures of other components to be discarded and disassembled.
Place the activated airbag into a tough plastic bag;
Ensure to seal the plastic bag properly;
Wash both hands carefully after disposal of the activated airbag.
(12) Maintenance of SRS system wiring harness
Warning: Before carrying out any maintenance, the SRS system must be disconnected. Please
refer to "Disconnection of airbag system" of this manual.
The connectors used in the SRS system are made of special material to ensure the good
conductivity of the low power circuit. The airbag wiring harness assembly must be replaced
if the plug is damaged. Do not try to use any other type of connectors to replace the connector
of this connector.
T-60