Chery automobile Service Manual page 422

12. Install the interior fastening frame with an
angle of 45 degrees, front high rear low
respectively, firstly fasten the front part,
and then push the rear section rearward. A
fastening bolt shall be tightened in the rear
middle area of interior fastening frame to
prevent dropping.
Tighten the fastening bolts of interior
13.
fastening frame. Install the black fastening
bolts in the reverse order of step 8, and as
the order shown in the figure, from front
middle to both sides. Pay attention to the
engagement between motor drive shaft and
gear. Finally install the silver fastening
bolts from the rear middle to both sides.
14. Install the motor and the SCU in the
reverse order of step 6.
15. Install the interior trim rim (push upwards
as shown in the figure, pay attention that
the clamp should be aligned to the
groove). Install the additional strip if
necessary.
S-75