Removal & Installation Of Fuel Filler Cap; Removal & Installation Of Exterior Rearview Mirror; Removal & Installation Of Radiator Grille - Chery automobile Service Manual

REMOVAL & INSTALLATION OF FUEL FILLER CAP
REMOVAL
----Loosen the two screws between the filler
cap and car body.
INSTALLATION
----Install in the reverse order of installation
ADJUSTMENT
----Keep the size at (4±0.5 mm and flatness
error between cap rim and the fender at
±0.5mm, which shall not affect the
appearance.
REMOVAL &
EXTERIOR REARVIEW MIRROR
REMOVAL
----In removing
instructions shall be followed to remove
front door trim panel (refer to REMOVAL
& INSTALLATION OF FRONT DOOR
TRIM PANEL)
----Remove inner triangular block of the
mirror.
----Remove the three screws connecting the
mirror and door trim panel. Pull the mirror
connector off to remove the mirror.
INSTALLATION
----Install in the reverse order of removal.
Tightening torque for bolts is 3±0.3N·m.
REMOVAL &
RADIATOR GRILLE
REMOVAL
----Take out the four bolts between the grille
top and front end panel to remove radiator
grille as shown in the right figure.
INSTALLATION
---- Install in the reverse order of removal.
Tightening torque for bolts is 3.5±2N·m.
INSTALLATION
the mirror, relevant
INSTALLATION
S-6
OF
OF