Take off 3rd driven gear snap ring B from
output shaft, and take off 3rd driven gear. And
take off 2nd driven gear, needle bearing, and
synchronizer ring from output shaft. (by
special tool)
Prize up reverse shaft by reverse gear idler
until both of them are off clutch housing.
Take off output shaft 1
st
assembly and 1
synchronizer ring, 1
gear and needle bearing, take off shift slice by
a special tool.
Screw off output shaft front bearing plate
fixing screw, take out output shaft front
bearing plate and output shaft.
Take off differential assembly.
Disassemble reverse gear fork and bracket,
returning spring and knob holder.
st
nd
and 2
synchronizer
st
driven
J-20
Special Tool
Special Tool