Chery automobile Service Manual page 294

Illustration 25
·Install the rod lock nut 3.
·Screw the outboard joint assy into the inner ball joint assy.
Illustration 26
Install the rack lock-plate and the inner ball
joint assy Refer to Illustration 25
·Apply Kerui 5242 sealant on the thread of the
inner ball pin.
· Install and screw the inner ball joint assy with
a special purpose tool. The tightening torque is
70~90N.m.
Install the protector, outboard joint assy and
single ear no-level clip Refer to Illustration
26
·Apply the grease on the lip of the protector 5,
and then install the hull oil cylinder assy and the
inner ball joint assy 7 in it.
· Clip the big end of the protector with the single
ear no-level clip 6.
·Clip the small end of the protector with the
clamp 4.
N-17