Chery automobile Service Manual page 229

Assemble the fork assembly into its right
position, and then assemble the idler shaft.
1 1st and 2nd fork
2 3rd and 4th fork
3 5th fork guide and bushing
4 reverse gear fork guide
Assemble input shaft rear axle pump plate A,
pay attention that the position of A should be
the same as in the picture. Put new front and
rear housing seal shim and assemble
transmission housing.
Put M17 bolt 1 into the threaded hole(see the
picture), grasp the fork shaft and fillip the
transmission housing with plastic hammer
until the bearing out of position to the right
place. Put in bolt 2 with 15Nm moment. Put in
reverse gear shaft bolt and fasten by 20Nm
moment, put in front/rear housing fixing bolt
and fasten by 25Nm moment; fasten the rear
bearing plate of input shaft by 15Nm moment.
J-23