Chery automobile Service Manual page 286

Removal and Dismantling of Steering Gear
Repair and adjust after the removal of the steering gear
Tightening Torque for the Fastener Set Components
Description
Hexagon flange bolt
Plug cap
Lock nut
Oil tube connector bolt
Inner ball joint-rack
Hexagon nut - outboard joint
Specification
Q1840812
M30X1.5
M32X1.5
M12X1
M12X1
M14X1.5
Illustration 5
Illustration 6
Shown as the table below
Quantity
1
1
1
2
2
2
Fix the steering Gear Refer to Illustration 5
·Fix the steering gear on the vises and keep the
input shaft flatly. Take off plug cap of the oil
inlet and the outlet to discharge the oil. Rotate
the input shaft for several times to discharge the
oil from the steering gear.
Remove the left and right steering link assy
(Refer to Illustration 6)
·Loosen the lock nut 3 of the left and right
steering link assy, and then remove the
outboard joint assy 1 and 2
N-9
Tightening Torque
N.m
20~30
35~45
40~50
15~25
70~90
4.9~9.8