Chery automobile Service Manual page 292

·Install the bearing 12, the upper oil seal 11 and the snap ring for hole 10.
· Apply the 5242 sealant on 1/4 circle thread of the hexagon flange bolt 24 and screw it to the
specified position of the pinion shaft. The tightening torque is 20~30N.m
· Screw the plug cap 26 1-2 threads, then apply proper quantities 5242 sealant onto the thread
of the plug cap and fix it into the hull. The torque is 35~45N.m.
Illustration 20
Illustration 21
Illustration 22
Install the valve core assy Refer to
Illustration 20
·Install the valve core assy 31 as the direction
of the skew gear tooth into the hull oil reservoir
Install the stop collar assy Refer to
Illustration 21
·Coat the cylinder side rack 31 with vinyl tape.
·Apply the white special grease on the inner
surface of the oil seal 30
·Press the stop collar assy into the oil reservoir
body 17
·Install the wire stopper 36 with a wire caliper
and position the stop collar assy.
Install the support device of the rack
to Illustration 22
·Apply the MoS
Lithium lubricating grease on
2
the slot area of the rack holder 23
·Install the rack holder 23 into the hull oil
reservoir assy 17.
·Install the spring 22.
·Screw the adjusting plug 21 into the hull oil
cylinder assy with a special purpose tool and
screw back 30º-40 º.
·Screw the lock nut 20 on the adjusting plug.
·Install the limiting plug of the rack end.
N-15
Refer