Valve Cover And Gasket - Chery automobile Service Manual

VALVE COVER AND GASKET

Removal
Remove 9 bolts to take out the cupped gasket
and high tension wire support, clutch and
throttle cable support.
Remove the valve cover and gasket assembly.
Take the sheet gasket out.
Installation
Clean the junction face of the cylinder head
and the valve cover.
Push the wedge of the sheet gasket for the
valve cover into corresponding valve cover to
integrate them.
Install the combined valve cover and sheet
gasket assembly on the cylinder head.
Put 9 hexagonal-head long cylindrical end
bolts into the cupped gaskets and supports and
screw them into the cylinder head.
Tighten the bolts in 2 steps according to the
graphics and tightening order. First step:
tighten them to
4.0-6.0Nm.Second step: tighten them to the
moment of 8.0-10.0Nm.
the moment of
B-10
Valve Cover
Cupped
gasket