Chery automobile Service Manual page 150

Diagnostic trouble code: P0336 "Malfunction of improper signal of crankshaft
position sensor"
Item
Operation procedure
No.
Connect the
1 adaptor, and turn the ignition switch to
"OFF" position.
Disconnect the connector of rotary
sensor on the wiring harness, inspect
with multimeter to verify that the
2
resistance between 2# pin and 3# pin of
this rotary sensor is about 770~950Ω
under 20 .
Verify that the circuits between 2# and
3# pin of the rotary sensor connector and
3
34# and 15# pins of ECU are open, or are
short to ground or power supply.
Verify that the signal panel of flywheel is
4
in good condition.
diagnostic tester
G-41
Inspection
Follow-up procedure
results
and
Proceed to next step.
Yes Proceed to next step.
No Replace the sensor.
Repair and replace
Yes
the wiring harness.
No Proceed to next step.
Refer to diagnosis
Yes
Replace the signal
No
help.
panel.