Driver Belt, Tension Pulley And Generator; Determination Of Engine Timing Tdc For Cylinder 1 - Chery automobile Service Manual

DRIVER BELT, TENSION PULLEY AND
GENERATOR
Removal
Pull the abutment on the tension pulley by tools
to the direction of the generator (or align the
gauge holes on the front and rear part of the
tensioning device and drive a pin to fix the
tensioning device).
Remove the driver belt and the two fixing bolts
on the generator to take the generator out.
For installation, reverse the above removal
steps.
Tension pulley and Generator Bracket
Removal
Remove the three fixing bolts on the belt tension
pulley to take it out.
Loosen the connecting nuts on the cylinder head
and binding bolts on the cylinder block on the
generator bracket.
For installation, reverse the above removal
steps.
DETERMINATION OF ENGINE TIMING
TDC FOR CYLINDER 1
Unscrew 2 M6 bolts to remove upper timing gear
cover. Put one wrench on the bolts of crank
pulley, rotate the crank shaft clockwise (seeing
from the direction of pulley) until the top dead
center (TDC) gap indicator on the pulley lines up
with the TDC indicator (O) on the bottom timing
gear cover.
Note: The spark plug can be taken away
before rotating the crank for labor
saving.
B-7