Table of Contents
Advertisement
3-1. Extracting the Cassette Tape when
Tape Slacks
1. Remove the left panel. (Refer to section 2-2-1.)
2. While holding the cassette compartment so that it does
not rise, turn screw A (red) in the counterclockwise
direction with a phillips screwdriver until the tape
slacks slightly.
3. Turn screw B (red) in a counterclockwise direction
with a phillips screwdriver, and wind the tape slacked
in step 2.
4. Repeat steps 2 and 3 until the tape has been completely
wound.
5. After winding the tape, remove your hand from the
cassette compartment, and turn screw A further in a
counterclockwise direction so that the cassette
compartment rises, then extract the tape. If the cassette
compartment does not rise, press the claws on the side
of the cassette compartment with a thin screwdriver.
DSR-570WS/570WSP V1
Section 3
Troubleshooting
Point to notice when winding the tape:
1. Do not turn the screws A and B strongly.
2. Do not apply excessive tension to the tape.
Screw B
Screw A
Claw
3-1
Hide quick links:
Advertisement
Table of Contents
