Sony DSR-570WS Service Manual page 180

6-40. TR Arm Assembly Position
Check/Adjustment
Reel table position: Mini cassette position
Mode: PLAY
. Tool
Mini cassette tape (commercial product)
1. Run the mini cassette tape (commercial product),
and check that the TR arm hole should be
aligned more than half with the chassis hole, as
shown.
Specification:
The TR arm hole should be inside the chassis
hole during PLAY mode.
If it is not, perform the following adjustment.
. Insert a flat-blade screwdriver into part A of
the TR band assembly shown in the figure,
rotate it in the clockwise or counterclockwise
directions to adjust it.
m
. When performing the adjustment, hold the TR
band holder so that it does not rotate.
. Never touch the tape.
6-62
No.1 gear
TR arm hole
Chassis hole
(TR band assembly) part A
TR band holder
TR arm hole
Chassis hole Chassis hole
Chassis hole
TR arm hole
Specilication :
Align the TR arm hole more than
half with the chassis hole, as shown.
Flat-blade screwdriver
TR arm (TG-2)
DSR-570WS/570WSP V1