Sony DSR-570WS Service Manual page 176

9. Set the rewinding torque measuring attachment
to the torque gauge (90ATG) as shown in the
figure as shown in the figure.
10. Place the torque gauge on the T reel table, press
the STOP key, and rotate the reel table to the
FWD side.
11. Adjust the torque gauge pointer to "0" and check
that the torque gauge value satisfies the
specification.
Specification:
FWD rewinding torque: 0.0052 ± 0.0002 N.m
If it does not, perform the following adjustment.
. When the torque value is towards the + side:
Press the REW key and adjust so that the
torque value is within the specification.
. When the torque value is towards the _ side:
Press the FF key and adjust so that the torque
value is within the specification.
12. Press the STOP key, and stop the reel table from
rotating.
6-58
(52 ± 2 g.cm)
Rewinding torque
mesuring attachment
Torque gauge
T reel table
Torque gauge
DSR-570WS/570WSP V1