Sony DSR-570WS Service Manual page 159

19. Remove the stopper washer shown in the figure,
and remove the mode slider.
Attachment
20. Attach the new mode slider in the reverse order
of step 19.
Apply grease on to the portion of the mode slider
shown in the figure.
21. Attach the parts removed in the reverse order of
steps 1 to 18.
n
When replacing the cam gear, apply grease on to the
groove of rear side of the cam gear, then attach it.
22. Adjust the phase as follows.
1) When attaching the cam gear and threading
gear, insert the reference pin into the hole of
each gear shown in the figure, and adjust the
phase.
2) At the same time, make sure that shaft a of
the slider arm should be seen from the long
hole of the cam gear.
Adjustment
23. Perform the tape guide height check/adjustment.
(Refer to Section 6-37.)
24. Perform the capstan FG DUTY adjustment at
Menu M601. (Refer to Section 10-2-1.)
25. Perform the REV rewinding torque check/
adjustment. (Refer to Section 6-38.)
26. Perform the TR arm assembly position check/
adjustment. (Refer to Section 6-40.)
27. Perform the FWD back tension check/
adjustment.(Refer to Section 6-39.)
28. Perform the tracking adjustment.
(Refer to Section 7-3.)
29. Perform the check after tracking adjustment.
(Refer to Section 7-4.)
30. Perform the check of self-recording tape
playback. (Refer to Section 7-5.)
31. Perform the switching position adjustment.
(Refer to Section 7-6.)
DSR-570WS/570WSP V1
Shaft a
(Slider arm)
Rear side of cam gear
Inserting hole for reference pin
Long hole
HC gear
Cam gear
Stopper washer
Mode slider
Apply grease
Apply grease
Shaft a should be seen.
Threading gear
Inserting hole for reference pin
6-41