Sony DSR-570WS Service Manual page 163

10. Remove the reel plate pressing link assembly
from the shaft (at three parts) in the arrow
direction as shown in the figure.
Attachment
11. Attach the new reel plate pressing link assembly
in the reverse order of step 10.
12. Attach the parts removed in the reverse order of
steps 1 to 11.
n
When attaching the parts, make sure that the S side
reel table assembly and T side reel table assembly,
and the sub reel gear (S) assembly and sub reel gear
(T) assembly are not mixed up with each other.
Check/Adjustment
13. Perform the reel table FWD/REV rewinding
torque check/adjustment. (Refer to Section 6-38.)
14. Perform the TR arm assembly position check/
adjustment. (Refer to Section 6-40.)
15. Perform the FWD back tension check/
adjustment. (Refer to Section 6-39.)
16. Perform the check after tracking adjustment.
(Refer to Section 7-4.)
17. Perform the check of self-recording tape
playback. (Refer to Section 7-5.)
DSR-570WS/570WSP V1
Reel plate pressing link assembly
6-45