Sv-213 Board - Sony DSR-570WS Service Manual

2-9-8. SV-213 Board

1. Open the right panel. (Refer to Section 2-2-2.)
2. Remove the ES-26/26P and DPR-141B boards.
(Refer to Section 2-9-4.)
3. Remove the screw (B2.6 x 4) and remove the dust-
proof sheet.
4. Disconnect the two flat cables (CN501 and CN502) and
two flexible cards (CN504 and CN505) from the SV-
213 board.
5. Remove the three screws (PWH1.4 x 2.5), disconnect
the connector CN500, and remove the SV-213 board.
6. Return the board to its original position with the
reverse procedures of removal.
Point to notice when disconnecting the connector:
In order to prevent the board from damage, pull out the
connector CN500 gradually.
Point to notice when connecting the connector:
Be sure not to apply excessive force to the component side
of the SV-213 board when connecting the connector
CN500.
Point to notice when removing/installing the board:
Be very careful not to damage the connectors, harnesses,
and flexible card boards that are connected to the MB-833
board.
DSR-570WS/570WSP V1
Dust-proof sheet
Screw
PWH1.4 x 2.5
Screw
CN500
MB-833 board
PWH1.4 x 2.5
SV-213 board
CN502
B2.6 x 4
CN505
CN504
CN501
2-19