Sony DSR-570WS Service Manual page 54

Battery Preset Adjustment 1
1. Set the SYSTEM MENU (refer to Section 4-1-2), and
select the "Battery Preset Adjustment 1 mode (Menu
No. 501)" (Refer to Fig. A).
2. Press the RESET (MENU SET) button to blink the
voltage displayed on the display window (Fig. B).
Adjust the DC power supply so that the digital
voltmeter shows 11.30 V (Fig. 1).
3. Press the RESET (MENU SET) button. (The value set
will be written in the EEPROM) and "YES" will be
displayed when the desired voltage is set (Fig. C). "no"
will be displayed when an error occurs while writing in
the EEPROM and the value could not be set (Fig. D).
In this case, repeat steps 1 to 3.
m
. Set the voltage as 11.30 ± 0.01 V.
. The voltage value shown on the display window is for
reference only.
. If this menu is set by mistake, always press the MENU
button to exit from this menu. Never press the RESET
(MENU SET) button. When pressing the RESET
(MENU SET) button, the data being set will be written.
Battery End Adjustment
1. Set the SYSTEM MENU (refer to Section 4-1-2), and
select the "Battery end setting mode (Menu No. 502)"
(Refer to Fig. A').
2. Press the RESET (MENU SET) button to blink the
voltage displayed on the display window (Fig. B').
Adjust the DC power supply so that the digital
voltmeter shows 10.98 V (Fig. 1).
3. Press the RESET (MENU SET) button to write the set
value in the EEPROM. "YES" will be displayed when
the desired voltage is set (Fig. C'). "no" will be
displayed when an error occurs while writing in the
EEPROM and the value could not be set (Fig. D'). In
this case, repeat steps 1 to 3.
m
. VTR operations stop according to the battery end voltage
set. Set the voltage as 10.98 ± 0.01 V.
. The voltage value shown on the display window is for
reference.
. If this menu is set by mistake, always press the MENU
button to exit from this menu. Never press the RESET
(MENU SET) button. When pressing the RESET
(MENU SET) button, the data being set will be written.
2-36
Display window (LCD)
A
Blinking menu No. (When changed)
B
Voltage and A/D coversion value can be input
C
Save OK
D
Save NG
Display window (LCD)
A'
Blinking menu No. (When changed)
B'
Voltage and A/D coversion value can be input
C'
Save OK
D'
Save NG
DSR-570WS/570WSP V1