Sony DSR-570WS Service Manual page 57

2-16. Replacing the Flat Cables, Flexible
Card Wires/Boards
. Replace the flat cables, flexible card wires and boards as
follows:
Three types of connectors are also used.
. In order to keep the flexible card wire and board longer
life, be very careful not to bent them when handling
because they are remarkably sensitive.
Vertical Type Connector
. Disconnecting
Slide the * marked section in the arrow direction,
release the lock, and disconnect the flexible card
wire.
*
. Connecting
Lift up the * marked sections, and insert the flexible
card wire in the connector while paying attention to
the contacting surface of the flexible card wire.
After fully inserting until it goes, push down the
*marked sections to lock the flexible card wire.
*
n
When lifting up and down the * marked sections, be
sure to hold both ends of connector.
DSR-570WS/570WSP V1
. Disconnecting
Open the * marked section in the arrow direction,
release the lock, and disconnect the flexible card wire.
*
. Connecting
Lift up the * marked section, and insert the flexible
card wire in the connector while paying attention to the
contacting surface of the flexible card wire.
After fully inserting until it goes, push down the *
marked section to lock the flexible card wire.
Contact face
*
*
Contact face
*
2-39