Table of Contents
Advertisement
2-14. Battery Preset and Battery End
Voltage Adjustment
This section explains the battery preset adjustments and
battery end voltage adjustment.
To perform these adjustments, supply the DC power from
an external DC power supply and use the SYSTEM
MENU of the unit.
n
Perform "Battery Preset Adjustment 1" and "Battery End
Adjustment" in order of description.
However, "BP Battery Preset Adjustment 2" can be
performed in dependently.
Settings at shipment: Battery preset voltage: 11.30 V
Battery end voltage: 10.98 V
BP battery preset voltage: 13.00 V
Equipment required: DC power supply, Digital voltmeter,
DVCAM cassette tape
LIGHT switch (Right side panel) →
Switch settings:
OFF
TALLY switch (Rear side) → OFF
OUTPUT/DL/DCC + switch (Right
side panel) → BARS
Setting
1. Remove the bottom panel. (Refer to Section 2-2-3.)
2. Connect the DC power supply to DC IN connector.
3. Insert a cassette tape, and set the unit into the REC
mode.
m
. Touch the lead tip of the digital voltmeter to pin 6
(GND) and pin 12 (DC power) of connector CN6 on the
CP-373 board as shown in Fig. 1, and adjust the DC
power supply to the specified voltage of each item.
. Be careful not to touch the lead tip of the digital
voltmeter to the chassis and other connector pins as this
may cause a short circuit.
DSR-570WS/570WSP V1
<Bottom view>
CN6 (CP-373 board)
EARPHONE
12
DC IN
DC IN connector
CP-373 board
Fig.1
6
DC power
supply
2-35
Hide quick links:
Advertisement
Table of Contents
